Proface FP3900 - 19 Flat Panel" - Manual (Page 39)

FP3000 Series User Manual
3-6
3.5 FP-3900T Series
A:TFT Color LCD
The display monitor for your host unit.
B:Touch Panel
Allows you to switch screens or write data to the host.
C:Power Connector (socket)
Provides the input and ground terminals for a power
cable.
D:Setting Switch
By opening the cover, the Dip switches and slide
switch are seen. Each switch can set a operation mode.
E:Analog RGB Connector
Connector for analog RGB interface
F: DVI-D Interface Connector
Connector for DVI-D interface
G: Serial Connector
Connector for Serial (RS-232C) interface. Used for
sending touch panel data to between the hosts.
H:USB Connector (Type B)
Connector for USB interface. Used for sending touch
panel data to the hosts, or used as an upstream port for
USB-HUB.
I: Front LED
Used to indicate the condition of the power supply, a
backlight burnout or image signal input.
J: Front USB Connector (Type A)(FP3900-T41-U only)
A downstream port for embedded USB-HUB in
conformity with USB2.0/1.1 standard, which is used
for connecting USB devices. Connect the USB
connector (H:USB connector) and Host PC for Front
USB connector use.
Rear
Bottom
A,B
J I
Front
C D E F G
H
SEE 6.1 Operation Mode Setup (page6-2)
SEE 6.1.2 Status of Front LED in Operation
Modes (page6-4)