Brocade NetIron CER 2000 Series Hardware Guide (Supporting R05.6.00) - Manual (Page 41)

Brocade NetIron CES 2000 Series and NetIron CER 2000 Series Hardware Installation Guide 31
53-1003029-02
Chapter
3
Installation
System unpacking
DANGER
The procedures in this manual are for qualified service personnel.
The Brocade systems ship with all of the following items. Please review the list below and verify the
contents. If any items are missing, please contact the place of purchase.
Package contents
The package contains the following:
• Brocade NetIron CES 2000 Series 2000 or NetIron CER 2000 Series 2000 series device
• 115V AC power cable (for AC sourced devices)
General requirements
To manage the system, you need the following items for serial connection to the router:
• A management station, such as a PC running a terminal emulation application.
• A straight-through EIA/TIA DB-9 serial cable (F/F). The serial cable can be ordered separately
from Brocade.If you prefer to build your own cable, refer to the pinout information in
“Port
specifications” on page 63.
You use the serial connection to perform basic configuration tasks including assigning an IP
address and network mask to the system. This information is required for managing the system
using Brocade Network Advisor or using the CLI through Telnet.
DANGER
Do not use the handles on the power supply units to lift or carry a device.
CAUTION
Before plugging a cable to any port, be sure to discharge any static charge stored on the cable by
touching the electrical contacts to ground surface.