Brocade NetIron CER 2000 Series Hardware Guide (Supporting R05.6.00) - Manual (Page 93)

Brocade NetIron CES 2000 Series and NetIron CER 2000 Series Hardware Installation Guide 83
53-1003029-02
Copper or Fiber optic module replacement
6
CAUTION
For safety reasons, the ESD wrist strap should contain a series 1 Meg ohm resistor.
• The protective covering that you removed from the copper or fiber optic module when you
initially installed the module.
Follow the steps given below to remove a copper or fiber optic module from a Gigabit Ethernet or
10-Gigabit Ethernet port.
1. Put on the ESD wrist strap and ground yourself by attaching the clip end to a metal surface
(such as an equipment rack).
2. Disconnect the copper or fiber cable connector from the port connector.
3. Insert the protective covering into the port connectors.
4. Pull the copper or fiber optic module out of the port by pulling the bail latch forward, away from
the front panel of the module. This unlocks the module from the front panel. On 1000BaseSX
ports, the bail latch is enclosed in a black sleeve, and on 1000BaseLX ports, the bail latch is
enclosed in a blue sleeve.
NOTE
The bail latch may be attached to either the top or the bottom of the mini-GBIC.
5. Grasping the bail latch, pull the copper or fiber optic module out of the port.
6. Store the copper or fiber optic module in a safe, static-free place or in an anti-static bag.
7. Install a new copper or fiber optic module in the port. For information about performing this
task, refer to “Installing a new Copper or fiber optic module” on page 83.
Installing a new Copper or fiber optic module
You must install a fiber optic module (SFP, SFP+, or XFP transceiver) in each Gigabit Ethernet and
10-Gigabit Ethernet fiber port you want to use.
You can install a new fiber optic module in a port while the device is powered on and running.
1 Bail latch