Brocade NetIron CER 2000 Series Hardware Guide (Supporting R05.6.00) - Manual (Page 50)

40 Brocade NetIron CES 2000 Series and NetIron CER 2000 Series Hardware Installation Guide
53-1003029-02
Redundant power supply installation
3
FIGURE 37 The DC power supply
4. Insert the wires into the DC wiring assembly ( Figure 38 ).
5. Use the wire tightening screws to secure the wires.
6. Insert the DC connector with wires to the power supply and tighten the two assembly screws.
FIGURE 38 The DC wiring assembly
1 Wire tightening screws 2 Assembly screws