Ac power supply, Power supplies for the devices – Brocade NetIron CER 2000 Series Hardware Guide (Supporting R05.6.00) User Manual
Page 81
Brocade NetIron CES 2000 Series and NetIron CER 2000 Series Hardware Installation Guide
71
53-1003029-02
Power supply replacement
6
This command displays status information for the power supplies and the fans. The power supplies
are numbered from left to right. These numbers assume you are facing the front of the device, not
the rear.
If the display indicates “Installed (Failed)” for any of the slots, the power supply installed in that
particular slot has failed.
AC power supply
FIGURE 47
AC power supply
Power supplies for the devices
The device ships with one alternating-current (AC) power supply or direct-current (DC) power supply.
All models have two power supply slots, enabling you to install a second power supply for
redundancy. If desired, you can install a second supply for redundancy.
If you need to install a redundant power supply, it may be easier to install it before mounting the
device, although the power supplies are “hot swappable” and can be installed or removed after the
device is mounted and powered on. Brocade recommends that you disconnect the power supply
from AC power before installing or removing the supply.
CAUTION
Changes or modifications made to this device that are not expressly approved by the party
responsible for compliance could void the user's authority to operate the equipment.