Copper or fiber optic module replacement, Removing a copper or fiber optic module – Brocade NetIron CER 2000 Series Hardware Guide (Supporting R05.6.00) User Manual
Page 92
82
Brocade NetIron CES 2000 Series and NetIron CER 2000 Series Hardware Installation Guide
53-1003029-02
Copper or Fiber optic module replacement
6
To replace the Brocade fan tray, follow these steps.
1. Power down and unplug the chassis.
2. Unscrew the two screws that secure the fan tray to the chassis.
FIGURE 56
Replacing the fan tray
3. Slide the fan tray out
4. Slide the new fan tray in and tighten the screws to secure it to the chassis.
5. Plug the chassis back in and power up.
Copper or Fiber optic module replacement
You can remove an SFP, SFP+, or XFP from a port and replace it with a new one while the Brocade
device
is powered on and running.
This section provides information about the following tasks:
•
Removing a copper or fiber optic module
•
Installing a new copper or fiber optic module
•
Cabling a fiber optic module
Removing a Copper or fiber optic module
You can remove a copper or fiber SFP (also called a mini-GBIC), SFP+, or an XFP from a port while
the Brocade
device
is powered on and running.
Before removing a copper or fiber optic module, have the following on hand:
•
An ESD wrist strap with a plug for connection to the ESD connector on the Stackable device.