Rice Lake Condec UMC600IS - Manual (Page 25)

22 UMC 600IS Installation Manual
3.3.3 Option 3 – Time and Date
The time and date clock is attached to the battery-backed memory (U4) and will continue running when the
indicator is off. A variety of formats for printout are available, and access is provided for adjustments (see
Table 3-13).
NOTE: Option 3 must be enabled when using the Option 4 auto shutoff feature.
NOTES:
• Prior to setting the time and date, select the current time for parameter 3.1(either dLS or Std). This
feature selection now allows the operator to increment or decrement the time by one hour when clocks
are changed from dLS to Std. To change the time, access Option 3 using the
TARE key and then push the
Lb/kg key to toggle from dLS to Std or vice versa.
• The display for parameters 3.6 and 3.7 alternates between the parameter selection and the current data
value. This continues until new data is entered via the numeric keys. After keying in new numeric data,
press the
ENTER key to save the new value. The display will again alternate.
• Time and date can be directly accessed in normal running mode by pressing both the 0 and 3 keys for a
few seconds. This allows the time or date to be changed without using the option switches. To exit, press
the
0 key.
Figure 3-11. Option 3 Menu
Prompt Display Interpretation Notes
Time and date option Time and date settings can be directly
accessed in normal running mode by
holding down both the
0 and 3 keys
for a few seconds. The operator can
then make changes without using
option switches. To exit, press the
0
key.
OP.3 oFF Off (time and date disabled)
OP.3 On On (time and date enabled)
3.1 Std
dLs Standard Time
Daylight Savings Time
3.2 12
24 Selects 12- or 24-hour time display
3.3 A
P AM (A) or PM (P) setting when 12-hour clock is selected
3.4 Un
Ab
on Selects the location of printed time and date data: under (Un),
above (Ab), or on the same line (On) as weight data.
3.5 LEt
nO Prints date in letters (LEt) or numbers (nO).
For example: Sept 1, 1999 vs. 09/01/99
3.6 tI Time. Use numeric keys to enter the time in hours, minutes and
seconds (HHMMSS), then press the
ENTER key (see Note
below)
The display for parameters 3.6 and
3.7 alternates between the parameter
and the current data value. This
continues until new data is entered
using the numeric keys. After entering
new data, press
ENTER again to
alternate the display.
3.7 dA Date. Use numeric keys to enter the date in month, day and
year format (MMDDYY), then press the
ENTER key (see Note
below)
XXXXXXX XXXXXXX XXXXXXX XXXXXXX OPTION 5 OPTION 4 OPTION 3 OPTION 2 CALIBR CONFIG OPTION 6 OPTION 7 SERIAL OPTION 1
TYPE
OFF ON
Off
TIME/DATE DLS HR A–PT
On
Std.
dLs
12
24
Am
Pm
POS TI DATE
Under
LEt
letter
hh.mm.ss mm/dd/yy
Above
On
nO
number