Rice Lake Condec UMC600IS - Manual (Page 39)

36 UMC 600IS Installation Manual
6.0 Appendix
6.1 Error and Status Messages
The UMC 600IS indicator provides a number of error and status messages. When an error occurs, the message is
shown on the indicator display. Table 6-1 lists these messages and their meanings.
Error Message Description Solution
Err1 Loss of configuration Reconfigure
Err1a Loss of option configuration
Err1b
Err1c
Err2 Loss of zero calibration Recalibrate
Err3 Loss of span calibration
Err5 Loss of auto tare Acquire tare
Err6 Loss of auto zero Acquire zero
Err9 Not in span calibration Program span value before entering
Err 10H Input > 3.3 mV/V at full scale Recalibrate span to set full scale in the range 0.4–3.3 mV/V
Err 10L Input < 0.4 mV/V at full scale
Err 10P PTZ (push to zero) > 2% Perform zero calibration
Err 10– PTZ > weight used for span calibration
OL Gross overload Check load cell wiring
UL Gross underrange
CAL Calibration successful —
Table 6-1. UMC 600IS Error and Status Messages