Hired-Hand RollSeal Rollup Curtains: ROLLUP CURTAIN SYSTEM Rev 11-05 - Manual (Page 14)

Part No. 4801-5138 Rev 11-05 Rollup Curtain System Page 14
Curtain
Conduit
Straps
0.922" (2.3 cm) O. D. rod fits inside
top pocket of curtain.
NOTE: Assembly fits flush against
bottom of bracket.
FIG. 5
Attaching Curtain To Stringer
Top
Curtain
Bottom
Curtain
Double
Stack System
Curtain
Conduit
strap
Rod
& curtain
Curtain Installation Instructions
Continued On Next Page
→
IMPORTANT!
Start attaching
curtain at one
end. Pull the
slack out as you
go!
7.5 Conduit Pipes & Curtains
There are two rods that fit into the pockets of curtain. 0.922" (2.3 cm) O.D. rod fits into the upper pocket
of curtain. 1.029" (2.6 cm) O. D. rod fits into the lower pocket of the curtain.
1. Lay 0.922" (2.3 cm) O. D. rod in front of system. Unroll curtains. Slide 0.922" (2.3 cm) O. D. rod into top
pockets of curtains. Assemble rod/curtain for the entire length of system.
2. Fit curtain assembly underneath brackets of middle stringer of double stack system or top stringer of single
system. 0.922" (2.3 cm) rod should be flush against bottom of brackets as shown in diagram below. Align
ends of rod/curtain assembly with ends of system.
3. Attach 0.922" (2.3 cm) rod/curtain assembly to the stringer with conduit straps. IMPORTANT! Start
attaching curtain at one end and pull slack out as you go.
NOTE: Conduit straps should be located every 3 ft. (91 cm).