Hired-Hand RollSeal Rollup Curtains: ROLLUP CURTAIN SYSTEM Rev 11-05 - Manual (Page 22)

Part No. 4801-5138 Rev 11-05 Rollup Curtain System Page 22
9.2 Vertical Drive Option
1. Install right pinion assembly (6419-0100) to rack (0404-4520) as
shown in Fig. 14. Run pinion assembly about half way down rack as
shown.
2. Repeat for left pinion assembly (6419-0104) and rack (0404-4520).
NOTE: Make sure that both pinion assemblies are the same distance
from top of racks.
3. Attach gear pinion adapter (0404-5144) to the pinion assembly
(6419-0100).
4. Repeat for second pinion assembly. Use 3/8x16x2 HEX screws
(1004-1423) and lock nuts (1001-1457) to attach pinion adapters to
pinion assembly.
5. Install Rollup drive assembly to each end of motor/gear box. Fasten
gear pinion adapters (0404-5144) to each end of motor shaft with
3/8x16x2 screws (1004-1423) & nuts (1001-1457) provided.
6. Attach the Rollup Drive Gear Bracket (0404-5644) to the motor with 1/4x20x11/2 HEX screws (1004-7075).
7. Attach the Rollup Drive Gear Bracket (0404-5142) to the bottoms of the pinion assemblies with 3/8x16x1 HEX
screws (1004-1426) and nuts (1001-1446) provided.
8. Attach the Bumper Guard (0404-5711) to the Gear Bracket with 3/8x16x3 1/2 HEX screws (1004-7025) and
nuts (1001-1457) provided.
9. Go to Section 13 to attach the Rollup Drive Rack Mounts (0404-5141) to the top and bottom of the racks.
6419-0104
Rollup Pinion
Assembly-Left
Motor Drive-Vertical
Assembled
4' - 6450-5423
5'.- 6450-5422
10' - 6450-8017
1004-1423
Screw 3/8x16x2
Motor/Gearbox
Assembly
1004-1423
Screw 3/8-16
1001-1457
Lock Nut 3/8x16
0404-5644
Gear Bracket
0404-5711
Bumper Guard
Rack
6419-0100
Rollup Pinion
Assembly-Right
1001-1457
Lock Nut 3/8-16
0404-5144
Pinion Adaptor
1001-7075
Screw
1/4x20x11/2
1001-1426
Screw 3/8x16x1
Rack
Fig. 14
1004-70
Screw 1/4x20x11
1001-1446
Lock Nut 1/4x20
1004-7025
Screw
3/8x16x31/2