LumaSense Technologies LumaSoft Gas Multi Point 7860 - Manual (Page 15)

Chapter 2
_________________________________________________________________________
________________________________________________________________________
BE6027-12 LumaSoft Gas Software LumaSense Technologies A/S
7810 and 7860 Page 15 of 194
2.1.2 Installing LumaSoft Gas
The LumaSoft Gas software is delivered on a CD with an installation
program. Please refer to Appendix A how to perform the installation of
the LumaSoft Gas software. It is recommended that your system
administrator performs the task of installing the LumaSoft Gas program.
After the installation is successfully completed the LumaSense ->
LumaSoft Gas program menu is created.
The “LumaSoft Gas” program icon (Figure 2.1) is also placed on your
desktop for easy access to the program.
Figure 2.1 LumaSoft Gas desktop shortcut
2.2 Connecting the Monitor and the Multiplexer to a PC
The Monitor comes complete with an USB interface cable.
Optionally an Ethernet (TCP/IP) interface cable or a 9-pin to 9-pin null
modem RS-232 interface cable can be delivered.
2.2.1 Fitting the USB Cable
The USB interface cable can be connected while the gas monitor is
switched on.
Locate an USB port at the back of the PC; refer to your PC manual if in
doubt. Push the connector on the USB cable on to the USB port socket
on the PC.
Locate the output labelled at the back of the Monitor. Push the
connector at the other end of the USB cable on to this socket.