LumaSense Technologies LumaSoft Gas Multi Point 7860 - Manual (Page 59)

Chapter 4
_________________________________________________________________________
________________________________________________________________________
BE6027-12 LumaSoft Gas Software LumaSense Technologies A/S
7810 and 7860 Page 59 of 194
Parameters Units Default Unit
Humidity mg/m 3 , ppm, Tdew, kPa Tdew
Pressure mbar, mmHg, kPa kPa
Gas Concentrations mg/m 3 , ppm ppm
Table 4.2 The possible parameter units with defaults
Tension
By adjusting the Tension it is defined how soft/hard the lines between
the measuring points should be. If the tension is set to 0 the points are
connected by straight lines.
Figure 4.15 Define how hard/soft the lines between measurement points
should be
When all the settings has been adjusted press Next to proceed.
4.2.1.4 Configuration of the Graph Window (Channel view)
In this configuration window the trend properties are configured. The
trend can be given a title by entering a name in the Graph Title field.
(See Figure 4.16 ).