LumaSense Technologies LumaSoft Gas Multi Point 7860 - Manual (Page 99)

Chapter 4
_________________________________________________________________________
________________________________________________________________________
BE6027-12 LumaSoft Gas Software LumaSense Technologies A/S
7810 and 7860 Page 99 of 194
Figure 4.69 Select which gases should be displayed
Select unit: this enables to display the desired unit for each gas and for
the atmospheric pressure. Click in the select unit field, and the available
units for this parameter will be displayed.
Figure 4.70 Select the units in which the concentration should be
displayed
Press Add after each selected parameter, see Figure 4.71 . To insert the
second parameter before the first press Add Before. It is also possible
to remove a selected parameter by pressing Remove.