LumaSense Technologies LumaSoft Gas Multi Point 7860 - Manual (Page 53)

Chapter 4
_________________________________________________________________________
________________________________________________________________________
BE6027-12 LumaSoft Gas Software LumaSense Technologies A/S
7810 and 7860 Page 53 of 194
4.1.2 Stop Measurement
To stop the measurement, select Measurement and Stop, see Figure
4.5, or press the icon in the task bar.
Figure 4.5 Measurement pull-down: Stop
4.2 Presentation of Data in Graphical Window
The measurement data can be presented graphically in two different
ways either channel-wise or gas-wise.
If measurement data is presented channel-wise the gas filters is shown
in a graphical view for each channel. Proceed to Section 4.2.1 for
presentation of graphical data channel-wise.
If measurement data is presented gas-wise the multiplexer channels is
shown in a graphical view for each gas filter. Proceed to Section 4.2.2
for presentation of graphical data Gas View.
4.2.1 Presentation of Data in Graphical Window
Channel-View
To display measurement data graphically channel-wise select Graphical
Window>Single Channel with Selected Gases View in the View
pull-down menu. (See Figure 4.6)
Figure 4.6 View pull-down: Graphical Window>Single Channel with
Selected Gases View