LumaSense Technologies LumaSoft Gas Multi Point 7860 - Manual (Page 31)

Chapter 3
_________________________________________________________________________
________________________________________________________________________
BE6027-12 LumaSoft Gas Software LumaSense Technologies A/S
7810 and 7860 Page 31 of 194
3.1.1 Configuration of the USB interface
The System Configuration Setup window appears. Now you select the
USB radio button as shown in figure 3.5 in case it is not selected.
Figure 3.5 Select the USB communication interface.
To close the System Configuration Setup press the OK soft-key.
If the USB interface already was selected please make sure that the USB
interface cable between the PC and the 1412i/1314i/3434i Gas Monitor
is securely connected.
Finally please ask your Administrator to check for the presence of the
1412i USB driver in the Device Manager (Figure 3.6). Please note that
the 1412i USB driver also supports the 1314i and 3434i Gas Monitor.
Now proceed to section 3.2 in order to create a new task.