Spectra Precision Survey Pro 3.80 Recon GPS Reference Manual - Manual (Page 39)

Survey Menu – RTK
39
2FFXS\ *36 : is used to occupy the GPS reference point. A prompt
for the name of the GPS reference point is followed by the Occupy
Data Points screen (Page R-39). After measuring the coordinate at
the occupied point, you will return to the Offset Shots screen where
the new point can be stored with the applied offset.
6WRUH : prompts you for a point name and description and stores a
point for the current location.
6KRRW /DVHU : triggers the selected conventional instrument (laser
range finder) to take a shot to the offset. The measurements
available from the conventional instrument will return to the
distance and zenith angle fields, and if available, the azimuth
(horizontal angle).
$FFHSW : stores the new point with the applied offset.
Occupy Data Points Screen
The Occupy Data Points screen is used to collect measurements to
new points.
Local Coordinates : displays the local coordinates
computed from the current geodetic measurement.
Solution Quality : displays the quality of the current
measurement: the solution type, the number of satellites
used, and the horizontal and vertical precision computed
by the receiver.
Epochs : displays the number of epochs recorded since
the beginning of data collection.
Count Status : displays Measuring when we are receiving
fresh coordinates from the receiver and updating the
screen with the latest measurement.
Averaging is
displayed after you tap $FFHSW while we average the
number of epochs specified in the Epochs to Average on
Accept field on the Measure Mode Settings screen (if this
value is greater than 1). Suspended is displayed if we are not
receiving valid data from the receiver or while you are viewing a
separate screen (like GPS Status).