Spectra Precision Survey Pro 3.80 Recon GPS Reference Manual - Manual (Page 81)

Stakeout Menu
81
Rover is greater than 3 m
(10 ft) from the design
point. Rover is between 0.3 and 3
m (1 and 10 ft), from the
design point. Rover is within 0.3 m (1 ft)
of the design point.
Go EAST / WEST : displays the distance the rover must move in an
east or west direction to reach the design point.
CUT / FILL : displays the required cut or fill between the current
elevation and the design point.
5 Hz Mode : switches the receiver from One Hz to Five Hz mode.
When this box is checked, the receiver will compute positions five
times a second so the display will update in near real time while you
are roving to the point.
Note: When you switch from ROVING to OCCUPYING , the receiver
will be put back in one Hz mode for maximum precision while staking
the point.
5HI ƒ¶´« : opens a dialog where you can select a reference
direction or a reference point to orient the staking graphic. The
reference direction or the direction to the reference point is displayed
as a vertical line from the center to the top of the graphic.
2&&83<,1* / 529,1* : switches from ROVING to OCCUPYING
mode. When ROVING, the receiver is in dynamic mode and will
calculate your position as you move to the point. When
OCCUPYING,
the receiver is switched to static mode (depending on settings) and
will calculate the most precise position for the staked point.