Spectra Precision Survey Pro 3.80 Recon GPS Reference Manual User Manual
Page 84
GPS Reference Manual
84
Go EAST
/
WEST
: displays the distance the rover must move in an
east or west direction to reach the closest point on the line.
5 Hz Mode
: switches the receiver from one Hz to five Hz mode. When
this box is checked, the receiver will compute positions five times a
second so the display will update in near real time while you are
roving to the point.
Note: When you switch from
ROVING
to
OCCUPYING
, the receiver
will be put back in one Hz mode for maximum precision while staking
the point.
2&&83<,1* / 529,1* : switches from
ROVING
to
OCCUPYING
mode. When ROVING, the receiver is in dynamic mode and will
calculate your position as you move to the point. When
OCCUPYING,
the receiver is switched to static mode (depending on settings) and
will calculate the most precise position for the staked point.
Note: When
Store GPS Raw Data
on the Job/ Settings/ Measure Mode
card (Page R-8) is set to
+ Rx. Raw (
and / or
+OBN
for
Ashtech)
switching from
ROVING
to
OCCUPYING
will start a session in the
receiver, so you will be prompted for a point name and description.
The receiver session will be completed and the measurement stored
when you tap
6WRUH. The occupation is not stored in the Survey Pro
.RAW file if you toggle back to
ROVING
.
Results
/
Current Location
: displays either the directions to the
closest point on the line or the current local coordinate.
LEFT of Line
/
RIGHT of Line
/
ON LINE
: displays the position of the
rover with respect to the line. Left and right are relative to north.
ON LINE
is displayed when you are within the
Horizontal Distance
Tolerance
specified in the Stakeout Settings screen (see the
conventional Reference Manual).
Offset Dist.
: displays the perpendicular offset distance from the line
to the rover.
Station
: displays the station on the line associated with the offset
location. It is relative to the
Start Point
defined in the first screen.