Spectra Precision Survey Pro 3.80 Recon GPS Reference Manual - Manual (Page 93)

Stakeout Menu
93
Note: When Store GPS Raw Data on the Job/ Settings/ Measure Mode
card (Page R-8) is set to + Rx. Raw ( and / or +OBN for Ashtech)
switching from ROVING to OCCUPYING will start a session in the
receiver, so you will be prompted for a point name and description.
The receiver session will be completed and the measurement stored
when you tap
6WRUH. The occupation is not stored in the Survey Pro
.RAW file if you toggle back to ROVING.
Note: You must be within the boundary of the DTM before any cut /
fill information is provided.
' 9LHZ« : opens the 3D View screen (consult the conventional
surveying Reference manual) where a 3D view of the DTM can be
viewed from any angle as well as cut / fill information for the current
location.
Note: The ' 9LHZ« button is only available when Generate TIN
w\Staked Points is checked in the previous screen and at least three
stake points have been stored.
6WRUH : stores a point at the current rover location with the point
name shown in the St Pt field and the description in the Desc field.
Also advances the St Pt to the next available point name.
St Pt : is the point name that will be assigned to the next stored point.
Desc : is the description that will be assigned to the next stored point.
HR : is the height of the rod.
Data : shows the northing, easting, and elevation of the current rover
location.
Result : shows the computed elevation of the DTM at the current
location and the cut or fill necessary to bring the elevation at the
current location to the elevation of the DTM at the current location.