Spectra Precision Survey Pro 3.80 Recon GPS Reference Manual - Manual (Page 87)

Stakeout Menu
87
• )RUFH ),// 6ORSH : forces all computations to be based on a
fill slope.
The second button selects which information is displayed in the lower
corner of the screen from the following options:
• 9 0DS : displays a cross-sectional view at the current
station.
Note: When you tap a map view, an expanded view of the same map
will fill the screen.
Note: The Vertical Map will show an X at the location of each
previous shot. This can be useful in determining if the current
terrain will never intersect the slope (no catch point).
• + 0DS : displays an overhead view of the job.
• 1(= : displays the coordinates computed from the last
shot.
2FFXS\«: switches the receiver dynamics to static (depending on
settings) and opens the Occupy Data Points screen (Page R-39) where
data can be collected for the current point.
6LGH 6KRW : allows you to store a side shot measurement during stake
out. This button opens a prompt for the side shot point name and
launches the GPS Occupy Data Points screen. After you store the
new point (or cancel) you will resume with the Slope Staking screen.
Results : displays the results computed from the last 6KRW.
Obs. Slope : is the computed (observed) cut or fill slope based on the
last shot and the corresponding hinge point.
Des. Slope : is the design cut or fill slope.
Cut / Fill : is the cut or fill required for the current rover location to be
positioned on the design slope.