COSA Xentaur Xentaur XDTL-HT - Manual (Page 22)

22
Setup Menu
Measurement
Dewpoint Temperature Pressure Enclosure Temp
Unit
Buffer Size
Low Alarm
High Alarm
Critical Alarm
Gas Matrix
Tune
Unit
Buffer Size
Low Alarm
High Alarm
Critical Alarm
Unit
Buffer Size
Low Alarm
High Alarm
Critical Alarm
Unit
Buffer Size
Low Alarm
High Alarm
Critical Alarm
User Input 1
Offset
Slope
Buffer Size
Low Alarm
High Alarm
Critical Alarm
User Input 2
Offset
Slope
Buffer Size
Low Alarm
High Alarm
Critical Alarm
User Input 3
Offset
Slope
Buffer Size
Low Alarm
High Alarm
Critical Alarm
User Input 4
Offset
Slope
Buffer Size
Low Alarm
High Alarm
Critical Alarm
User input menu would not appear if the instrument is not configured with optional analog inputs.
Change measurement X engineering unit Go to Measurement > X > Unit
Change the number of samples for measurement X
averaging
Go to Measurement > X > Buffer Size
Set desired operating range for measurement X
2
Go to Measurement > X > Low Alarm
Enter bottom range value
Go to Measurement
> X > High Alarm
Enter top range value
Enable/disable treating measurement X alarm as
system fault
Go to Measurement > X > Critical Alarm
Change dew point calibration curve to new gas matrix Go to Measurement > Dewpoint > Gas Matrix
Manually initiate TruTune™ tuning Go to Measurement > Dewpoint > Tune
Change correction curve for analog input X
Go to Measurement > User Input X > Offset
Enter correction curve offset
Go to Measurement
> User Input X > Slope
Enter correction curve slope
Reset measurement alarms Select Reset Alarm on main menu
2 Low Alarm and High Alarm values are automatically converted when the engineering unit parameter is changed.