Fire-Lite P K-411UD Windows-Based Off-Line Programming Utility - Manual (Page 35)

Document #50802 Rev. B 1/5/99 P/N 50802:B 35
Customer
To program the Output Relay, click the down arrow to the right of the Output Relay text block to view the available
options as shown in Figure 5-21.
Clicking the desired selection will cause the choice to appear in the Output Relay text block. To enable the relay,
click the Enable text located above the text block. A black dot will appear in the white circle preceding the text,
indicating that the relay has been enabled. To disable the relay, click the Disable text. A black dot will appear in the
white circle preceding the text, to indicate the relay has been disabled. The programming of the Output Relay is
complete.
The AC Loss Delay Timer option can be programmed in this window if any Channel is programmed as AC Loss.
This option allows the digital communicator to delay sending an AC loss message to the Central Station for the
selected time period. Click the down arrow to the right of the AC Loss Delay Timer text block to view the available
options as shown in Figure 5-22. Use the scroll bar to view all of the options in this drop down window. Clicking the
desired time delay will cause the selection to be displayed in the AC Loss Delay Timer text block.
The Trouble Reminder option causes the digital communicator piezo to 'beep' every two minutes during a trouble
condition, after a trouble silence switch has been pressed. Click the Enabled text to enable this feature. A black dot
will appear in the white circle preceding the text to indicate the selection of this option. Click the Disabled text to
disable the Trouble Reminder feature. A black dot will appear in the white circle preceding the text to indicate that
the option has been disabled.
FIGURE 5-21: 411UD Output Relay Programming
FIGURE 5-22: 411UD Option Programming