Configuring general system settings, R settings (see – Fire-Lite PS Tools MS-9600 User Manual
Page 39
PS-Tools User Guide
636 Pt Addr. Panel
PS-Tools
04/2010
31
Configuring General System Settings
You can configure the timers, clock format, fire panel passwords, trouble reminder, daylight savings,
loop style, PC/Printer installed, printer baud rate, and banner display, for the fire panel in the General
System Settings pane. You can program the following fire panel features.
•
Timers option allows you to set the PAS (Positive Alarm Sequence) time delay, Pre-Signal
time delay, Waterflow Retard delay, and AC Loss delay.
•
Clock Format feature allows you to set the display format (24 hour or 12 hour) for time in the
FACP memory.
•
Fire Panel Passwords option allows you to change the factory set master and maintenance
passwords for the fire panel.
•
Trouble Reminder feature, when enabled, provides an audible reminder that an alarm or
trouble still exists on the FACP, after the control panel has been silenced. If the Trouble
Reminder feature is disabled and a trouble condition is not cleared within 24 hours, the panel
sends an abnormal 24 hour test message to the central station if connected.
•
Water Flow Devices Silenceable option provides the ability to silence any output circuit
programmed as a waterflow type, using the fire panel keypad.
•
Canadian Option feature, when enabled, automatically monitors addressable ionization smoke
detector sensitivity as per Canadian specifications. By default, this option is disabled.
•
Loop Style option allows you to select the loop style for Loop1 and Loop 2.
•
Day Light Savings feature if enabled, allows you to set the start and end date for day light
savings in the fire panel memory.
•
PC/Printer Installed option allows you to specify if the printer connected to the fire panel
requires supervision. The printer baud rate needs to be specified if a printer is connected to the
fire panel.
•
Banner Display option allows you to change the top two lines of the LCD display in the fire
panel. You can change the factory default readout to a custom defined readout, when the fire
panel is in Normal condition.
Figure 5-5
Configuring System Setup Options