Fire-Lite PS-Tools MS-9200UDLS User Manual
Page 65
Advertising
PS-Tools User Guide
198 Pt Addr. Panel
PS-Tools
08/2010
57
2.
Click Verify Setup to check the mapping of the input and output devices.
A warning in the right pane, is displayed listing all the detector devices and monitor modules,
which are not connected to an output/input device.
If there is a proper mapping between each input device and output device, a message appears to
indicate there are no warnings in verification.
3.
Click OK. The Verify Setup pane appears.
4.
If you want to create a PDF, click Print.
5.
If you want to view the SLC Loop Setup > Modules pane, click Prev.
6.
Click Next or click Simulation > Tabular View in the left pane, to view the Simulation >
Tabular View pane.
Advertising