KYORITSU 3127 - Manual (Page 29)

－ 26 －
6-5-5 How to review the measured DAR/PI values
Press the UP/DOWN button ( ) when measurements end. The measured
results are then displayed in following sequence. If the measurement ends earlier
than the intervals described in below (2), (3) or (4), blank displays aren’t shown
and returns to (1).
(1) Start of test
(A) Time when a test ends
(B) Value measured at the end of test
(resistance value)
(C) DAR or PI value
(D) Capacitance
(2) 1 min after the start of test
(2) 1 min after the start of test
(A) Elapsed time (15 or 30 sec)
(B) Value measured 15 or 30 sec after a start
of test. (resistance value, output voltage)
(C) DAR value
(D) Output Current measured 15 or 30 sec
after a start of test.
(3) 10 min after the start of test
(A) Elapsed time (1 min)
(B) Value measured 1 min after a start of test.
(resistance value, output voltage)
(C) DAR value
(D) Output Current measured 1 min after a
start of test.
(4) Results at 10 min after a start of test
(A) Elapsed time (10 min)
(B)
Value measured 10 min after a start of
test. (resistance value, output voltage)
(C) PI value
(D)
Output Current measured 10 min after a
start of test.
(A)
(B)
(C)
(D)
Return to (1)