Revo R16/8/4/DVR - Manual (Page 26)

User’s Manual
20
y PTZ Port Setup…: Select the button and set up the PTZ device you are connecting to the DVR. Check the Enable
RS485 box and set the port’s setting according to the PTZ device manufacturer’s instructions.
RECORD SETUP
General Settings (RECORD
¼ General Tab)
y Recycle When Disk Full: Selecting this box records over the oldest video data once all available storage space
has been used. When the box is not checked, the DVR stops recording once all available storage has been used.
y Resolution: Select the recording resolution.
NOTE: The total ips of all camera channels will be limited to 60 ips when set to High resolution and 30 ips
when set to Very High resolution.
NOTE: When set to High or Very High resolution, the maximum recording speed of each camera channel
decreases by half. However the maximum recording speed of 30 ips will be maintained if the number of cameras
that are turned On is two or less.
No. of cameras set to On and High or Very High resolution
0 1 2 3 to 16
─ 30 ips 30 ips 15 ips
y Record Audio: Selecting the box records audio from up to four inputs when video is recording.
NOTE: When installing more than four observation cameras, only audio sources from cameras connected to
the RJ-12 Video In 1, Video In 2, Video In 3 and Video In 4 connectors will be recorded.