Revo R16/8/4/DVR - Manual (Page 29)

Digital Video Recorder
23
y No.: Your DVR has built-in motion detection. Selecting the box turns the motion detection On and Off for each camera.
y Sensitivity: Set the DVR’s sensitivity to motion for Daytime and Nighttime independently from 1 (the least sensitive)
to 5 (the most sensitive).
y Zone: Define the area of the image where you want to detect motion; e.g., a doorway. The Motion Detection Zone
screen is laid over the video from the selected camera. You can set up motion zones one block at a time in groups
of eight individual block groups. A block group is positioned within the image area using the arrow buttons on the
remote control, and individual blocks within the block groups are selected or cleared using the camera buttons. You
can set up motion detection zones by selecting or clearing blocks. You can select or clear eight individual blocks
in a group at a time, and individual blocks within the group are selected or cleared by using the camera buttons on
the remote control. Pressing the
button on the remote control or clicking the right mouse button displays the
menu screen. Each item in the menu has the following functions;
Select/Select All – Activates highlighted blocks or all blocks to detect motion.
Clear/Clear All – Deactivates highlighted blocks so that they will not detect motion.
Reverse/Reverse All – Activates inactive highlighted blocks or all inactive blocks and deactivates active highlighted blocks
or all active blocks.
OK – Accepts changes and closes Zone setup.
Cancel – Exits Zone setup without saving changes.
NOTE: You can select the block groups to be selected or cleared by using the mouse. Place the mouse pointer
where you want to start the line. Hold down the left mouse button and drag the pointer to where you want to
end of the line. Release the mouse button and a group of blocks appears along the line you drew. You can
draw lines around shapes by repeating this process.
y Min. Blocks: Set the minimum number of detection blocks that must be activated to trigger a motion alarm for
Daytime and Nighttime independently.
y Alarm-Out…: Select the alarm-out signals (Alarm-Out and Beep) to be associated with the camera. The DVR will
alert you of the event by activating an external alarm or internal buzzer if motion is detected on the selected camera.
y Notify…: Select Mail if you want to send an e-mail to the address set during NETWORK – Mail setup when the DVR
detects motion on the selected camera.
NOTE: For the Notify action to work, the Mail should be enabled in the NETWORK – Mail setup.
y Motion Ignoring Interval: Set the motion ignoring dwell time. You can control excessive event logging and remote
notification of motion detected after the motion dwell time by adjusting the motion ignoring dwell intervals. The DVR
will not log and notify motion events occurred during the preset interval range. The recording for motion events will
not be affected by the Motion Ignoring function.