Error code notices, Troubleshooting – Revo R16/8/4/DVR User Manual
Page 51
Digital Video Recorder
45
ERROR CODE NOTICES
SYSTEM UPGRADE RELATED
CLIP COPY RELATED
No. Description No.
Description
0
Unknown error.
0
Unknown error.
1
File version error.
1
Device error.
2
Operating system version error.
2
Mounting failed.
3
Software version error.
5
File already existed.
4
Kernel version error.
6
Not enough space.
100
Upgrade device mounting failed.
7
Creating temporary file failed.
101
Package is not found.
8
Opening disk failed.
102
Extracting package failed.
9
Formatting disk failed.
103
LILO failed.
10
Database has been changed.
104
Rebooting failed.
11
Appending failed.
105
Invalid package.
12
Bad sector.
300
Remote connection failed.
13
No executable file.
301
Remote network error.
14
Opening executable file failed.
302
Remote upgrade is not authorized.
15
Writing executable file failed.
303
Saving remote package failed.
16
Creating image failed.
304
Remote upgrade is cancelled by the user.
400
USB device mounting failed.
401
Reading upgrade package on the USB device failed.
402
Copying upgrade package on the USB device failed.
500
System is busy clip copying.
TROUBLESHOOTING
PROBLEM
POSSIBLE SOLUTION
No Power
y
Check power cord connections.
y
Confirm that there is power at the outlet.
No Live Video
y
Check camera video cable and connections.
y
Check monitor video cable and connections.
y
Confirm that the camera has power.
y
Check camera lens settings.
No Live Video on the VGA
Monitor
If the DVR does not detect a VGA monitor automatically, press and hold the DISPLAY
button on the remote control for 5 seconds or longer to switch the video output from
Video out to VGA out.
DVR has stopped recording
If hard disk drive is full, you will either need to delete video or set the DVR to the Recycle
On (Recycle When Disk Full) Mode. See Chapter 2 – Installation & Configuration,
Main Setup – Record Setup for details.
The icon displays, however,
the DVR is not recording.
When the DVR is in the Pre-Event recording mode, the yellow and icons display
when there is no event, and the DVR is not recording. The red and icons display
when any event occurs and the DVR starts recording.
IR remote control does not
work properly.
y
Check the batteries in the remote control.
y
Check that nothing blocks the infrared sensor on the DVR.
y
Check the system ID setting for the remote control. See Chapter 2 – Installation &
Configuration, Main Setup – System Setup for details.