Blue-White Sonic-Pro Hybrid Ultrasonic Flowmeters - Manual (Page 32)

Page 32 Sonic-Pro
Industries, Ltd. Industries, Ltd.
ProSeries
by Blue-White Ind.
TM
All passwords must contain 5 digits. Each of
the five soft buttons represent 2 digits. The
numbers 5, 6, 7, 8 and 9 are interchangeable
with 0, 1, 2, 3 and 4 (respectively), so only
five choices are needed to enter any digit
from 0 thru 9. Entering the number 00000
(55555) effectively cancels the password
input or deletes an existing the password.
If you are prompted to supply a password
and fail to do so within 30 seconds, the
flowmeter reacts as if an incorrect password
was entered.
5.4.1.2
Entering Passwords
using the Soft Buttons
0 / 5
Setup Root Menu
Manage Configuration Sets
Configuration Set #1 К
К
Configuration Set #2
Configuration Set #3
Configuration Set #4
Configuration Set #5
Open a Saved Configuration Set
[ £ £ ¢¢¢ ] Enter Password
1 / 6 2 / 7 3 / 8 4 / 9
When setting or changing a password, the password must be entered a second time to
avoid entry errors. If the two entries to not match, the password will not be changed. To
remove password protection, you can take the normal action to set a password and then
delete it by e
. You are
then no longer prompted to enter the password but are instead immediately given access
to the protected data.
Many data items must be entered with reference to a specific unit of measure.
In the
able to specify three different units of measure; two relating to rate of
flow ( and one relating to total flow
( . Thus, rate of flow units can be configured for GPM and total
flow units can be configured for U.S. Barrels Liquid. Note that total units do not include
time as a variable.
When entering data in the ,
any value associated with rate of flow must be entered in the units of
measure that is currently configured at the time the data entry takes place.
For example, if in Flow Rate Volume Units you chose U.S. Gallons and in Flow Rate
Time Units you chose Hours, then Log Rate Setpoints must be entered in U.S. Gallons
per Hour. Similarly, if in Flow Total Volume Units you chose U.S. Barrels Liquid, Log
Total Setpoints must be entered in U.S. barrels liquid.
If the configured units of measure are changed, all editable data item displays will
automatically change to the new units, but they will represent the same actual
quantities. This happens because the flowmeter converts and stores these data values in
SI units.
ntering the number 00000 (55555) effectively deleting the password
Metering Setup branch of the Configuration Edit Menu (see section 5.4.3
below), you are
Flow Rate Volume Units & Flow Rate Time Units)
Flow Total Volume Units)
Metering Setup and the Process Control Setup screens
rate of flow
Any value
associated with the total flow must be entered in the total flow units of measure
configured at the time the data entry takes place. This requirement does not apply to
values in the Transducer Setup branch, (such as pipe sizes) which are governed by a
separate selection of units of measure (see section 5.4.2 below). When entering data by
making a selection from a list, it is not necessary to be aware of the units of measure in
force.
5.4.1.3
Units of Measure