PNI SeaTRAX - Manual (Page 27)

PNI Sensor Corporation DOC#1018154 r02
SeaTRAX User Manual Page 22
6.2.3 Changing Modules
Once a connection has been made, SeaTRAX Studio will recall the last settings. If a
different module is used, click the <Connect> button once the new module is attached.
This will reestablish a connection, assuming the module baud rate is unchanged.
6.3 Configuration Tab
Note: No settings will be changed in the module until the <SAVE> button has been selected.
6.3.1 Mounting Options
SeaTRAX Studio supports 16 mounting orientations, as illustrated previously in Figure
4-2. The descriptions in SeaTRAX Studio are slightly different from those shown in
Figure 4-2, and the relationship between the two sets of descriptions is given below.