Ampro Corporation DLP 5200 - Manual (Page 17)

15
5200 User’s Manual
Source Connections
Essential Cable
Connections
Before applying AC power to the 5000 Series projector, both IR receivers MUST BE
CONNECTED.


The IR receiver connections for the keyboard and remote control are located on the PC
card cage.


To access the PC card cage and connectors, turn the ¼ turn captive screw located on
the left side of the access panel, and gently open the door.


Route the connectors from the IR receivers up through the access slot located on the
underside of the projector.
!
Refer to the Remote Control and Keyboard Installation section for information on connecting the IR
Remote and Keyboard.
Source
Connection
The AmPro 5200 DLP™ projector incorporates “Auto-Search” and “Auto-Setup. This simply
means that the projector will automatically look and setup to new sources.
“ALICE’s” operation is based on a powerful PC operating system, which incorporates an
internal graphics card, so no external source is required. If no external source is detected,
ALICE will automatically switch to the internal source, providing that Auto-Search is enabled.
Refer to Basic Operation Section for additional information.
However, if an external source is desired, follow the diagram below for connecting the
source. Remember that ALICE will automatically select the source for you.