Ampro Corporation DLP 5200 - Manual (Page 21)

19
5200 User’s Manual
Menu System
As previously mentioned, ALICE operates on layers of command button menus. The initial command
buttons (below) allows you to access all of the user type projector controls.
Main Menu
Picture Allows the user to adjust image quality functions such as, brightness, and contrast, clock
phase and some advance settings as well.
Source Allows the user to explicitly select the display source type. I.E., RGB, RGB2, VIDEO etc.
Setup Wizard The Setup Wizard allows the user to step through predetermine setup sequence. This is
useful for the first time user.
User Setup This function allows you to perform a random type of channel setup or editing. This is
typically used by experience operators
Menu Menu presents additional commands and functions for the setup of a source (channel).
Chan 1: Sel
Channel
This button displays the currently active channel. Once selected, a channel list dialog box is
presented for manual selection of a desired channel setup.
In the case of Chan 0: Chan 0 indicates that the projector did not find a match for the
incoming signal and has either selected a setup from the “factory channel data” which is a
read-only list or has interpolated between the existing channels and has established a
temporary channel. See Auto-Search for operation and saving temporary channels.
Standby Puts the projector into the standby mode. Powers the lamp supply off. If you are using an
external monitor for projector operation, press STANDBY to re-display the image. Also, see
Remote Control operation.
Power
Powers the projector (Display engine/Lamp) OFF. Presents
the user with a decision dialog box. In the event this command
was entered intentionally, simply select NO on dialog box.
Important: It is recommended to leave the main AC power applied and the main AC switch
be left in the “on” position. If the main AC power is to be removed, allow a minimum of 2
minutes after engine shutdown before removing AC
.
Help Enters this help file.
Exit Exits the menu system and removes the menu(s) from the screen.