Warnings and important notes – Ampro Corporation DLP 5200 User Manual
Page 3
1
5200 User’s Manual
Warnings and Important Notes
First
Before operating this equipment, please read this manual carefully and completely. This
manual will provide you with the necessary information of the many functions and features,
and the necessary instructions for operation of this equipment.
Note
Data presented in this manual has been carefully reviewed for accuracy and reliability;
however, no responsibility is assumed for inaccuracies. The information contained in this
manual is subject to change without prior notice.
This symbol is intended to alert
the user that parts inside this
product are a risk of electrical
shock to persons.
This symbol is intended to alert
the user that important operating
instructions are in the
accompanying literature.
CAUTION
Electrostatic
Sensitive
Devices
This symbol is intended to alert the user that electrostatic sensitive devices
are employed in this product. When working inside the equipment, handling
or transporting printed circuit boards protect against “Electrostatic
Discharge”.
WARNING!
Bright Light
Source
This unit has an extremely bright light source. Do not look directly into the lens or the beam
of light. Be especially careful that children do not stare directly into the light.
WARNING!
Electrical Shock
To reduce the risk of electrical shock, do not expose this product to rain or moisture.
WARNING!
UV Radiation
The lamp contained in this product is an intense source of light and heat. One component of
the light emitted from this lamp is ultraviolet light. DO NOT LOOK INTO THE LENS
ASSEMBLY! Potential eye and skin hazards are present when the lamp is energized due to
ultraviolet radiation. Avoid unnecessary exposure.
Some medications are known to make individuals extra sensitive to UV radiation.
Main AC Line
The AmPro 5200 Series is auto ranging from 90-240 VAC. There is no need to pre-configure
any switches.
WARNING! AC
Ground
For your safety and proper operation of the projector, the projector MUST BE connected to a
properly wired and grounded outlet. An improperly grounded system can place hazardous
voltages on accessible metal parts of the projector and voids the warranty due to potential
damage to the projector.