Ampro Corporation DLP 5200 - Manual (Page 26)

Menu System
24
5200 User’s Manual
User’s Setup The User Setup command allows random access the setup controls of the projector.
The more experienced operator typically uses this function.
H Pos Centers the active video area within maximum display area. Adjust for minimal image
loss from side-to-side. Set the start point of the image on the left side. Adjust until the
left edge of the image is just visible, but not cutoff.
V Pos Centers the active video area within maximum display area. Adjust for minimal image
loss from top-to-bottom.
Pix Clock Reduces or eliminates vertical banding and focus problems by adjusting the length of
each horizontal line to match the computer line length. Adjust until the right side of the
image matches the display size or is not cut off by the border.
Clock Phase Adjust the timing of the pixels from the computer to match the timing of the pixels on the
projector. Proper adjustment will give sharper vertical lines by using one pixel on the
projector for a single pixel coming from the source.
Border The border command evokes the border control panel. The user can set the color of the
border to either on of the primary colors or virtually any combination of them. The border
is useful for centering sources that are less than the maximum 1024 x 768 resolution
onto the screen.
Format Use the Format command to select the closest matching format of the incoming signal
from the List dialog box.
Full Screen This command scales the incoming signal to the maximum resolution of 1024 x 768.
Unscaled This command selects the signals original resolution for displays or changes a scaled
signal back to its original resolution.
Restore Use this function to undo the last changes prior to the last save. See NOTE below.
NOTE: Channel data is saved when one of the following conditions occurs;
1.) 10-minutes after a change has been made, providing no other changes are made
within the 10-minute save window.
2.) A new channel has been selected, or an action occurs which selects a new channel
or source
3.) An explicit “Save As” command has been performed.