Ampro Corporation DLP 5200 - Manual (Page 27)

Menu System
25
5200 User’s Manual
User’s Setup “continued”
Scaling Provides the user with the ability to blank all four sides, Size or “zoom” the image in the
horizontal, vertical or both directions, center the image horizontally, vertically or snap
the image to horizontal/vertical centers. See Scaling controls.
Blanking - Adjust the four sides of the
image until all unwanted video is
eliminated or wanted information is
visible.
Zoom – Adjust the image size in the
horizontal, vertical or both directions until
optimal or desired effect is achieved.
Center – Center the image horizontally,
vertically or snap the image to
horizontal/vertical centers.
Factory Default This command changes the current channel to predetermined factory default. Once
evoked, the user is presented with a confirmation widow. Once overwrite is selected, all
previously channel changes will be lost.
Advanced Evokes an additional function button bar. Under the Advance command the following
functions are available:
Clamp Select the required black level clamp point. Select between “Back porch” (typically
associated with Video or RGB 3-wire) or “Sync tip” ” (typically associated with RGB 4/5-
wire) or “Tri-Level” ” (typically associated with HDTV) mode of operation on a channel-
to-channel basis. See Clamp pop-up option box.
Flagging Reduces the image flagging, tearing or jittering at the top and/or bottom of the image.
Once selected the Flagging adjustment pop-up window is presented.