Ampro Corporation DLP 5200 - Manual (Page 56)

ALICE Help Guide 1
54
5200 User’s Manual
BIOS
Configuration
Press <Delete> to enter the main BIOS screen and check the following parameters

IDD HDD AUTO DETECTION


Select the setting that includes LBA mode

Press <Enter> three more times and answer NO to each prompt.

STANDARD CMOS SETUP


Be sure primary type = user, mode = LBA, and reported drive size corresponds to
actual drive size.

Enter correct date and time


Set HALT ON to NO ERRORS


Set drive A to 1.44M, 3.5 in.

Set VIDEO to EGA/VGA

BIOS FEATURES SETUP


Boot sequence is C, A


Boot UP Num Lock is OFF


P/S2 mouse function is enabled


Exit to Main menu

CHIPSET FEATURES SETUP

Auto configuration is enabled


DRAM timings is 60ns


System cacheable is enabled

Video BIOS cacheable is enabled

Exit to Main menu

POWER MANAGEMENT SETUP

Power Management is disabled

Exit to Main menu

PNP/PCI Configuration

Resources Controlled By is Auto

Exit to Main menu

INTERGRATED PERIPHERALS

IDE HDD Block mode;………….….………..…. enabled


IDE PIO for all four ports;………….………..…. enabled

On Chip Primary and Secondary PIO;…….…. enabled


PCI slot IDE 2
nd
channel;………….………..…. disabled


Onboard FDC controller;………….………..….. enabled

Onboard UART1;………….………..………….. 3F8, IRQ4


Onboard UART2;………….………..………….. 2F8, IRQ3


Onboard Parallel Port;………….………..……. 378, IRQ7


Parallel Part Mode;………….………..……….. normal or SPP

Exit to Main menu
Select SAVE & EXIT, then enter “Y” to the resulting dialog box. System will now re-boot.