Ampro Corporation DLP 5200 - Manual (Page 53)

ALICE Help Guide 1
51
5200 User’s Manual
Flow
Chart 1
Boot-Up
Problem
Did the
system boot
properly
Press DELETE to enter the main
BIOS screen
Are the
settings
correct?
Correct the settings
See
BIOS
Configuration
Procedure
Is the
problem
resolved?
No
No
Turn the projector "off" (toggle the main AC switch "off").
Disconnect the main AC power cord from the projector.
Lossen the two captive screws located on either side of the projector towards the
front.
Lift up and lock the top cover in place.
Remove the PC cover-remove the six (6) #6 phillips screws securing the cover in
place.
Check to see if the IDE power, control and data cables are properly connected.
Check system boards and make sure all are well seated in place.
Be Sure that no cable or any other objects are making contact with the CPU fan
No
Yes
Replace the PC card cage cover, reconnect the system AC and turn the main AC
switch on.
Apply AC power to the projector. Toggle the projector "on".
Verify the boot sequence.
Be sure that the IR Keyboard/Mouse and the IR remote
Mouse are properly connected.
1
Yes
Yes
2
If desired, connect an
external monitor to the
projector VGA "out"
connector.