Ampro Corporation DLP 5200 - Manual (Page 25)

Menu System
23
5200 User’s Manual
Setup Wizard The SETUP WIZARD will guide the first time user through a step-by-step setup of the various
image parameters or even if you are an experience user, the Setup Wizard provides a quick
method of setting up a new source.
Main Screen
and Functions
The Setup wizard screen provides you with the function list. Use the Back/Next buttons to
move through the list. The Setup Wizard screen also provides the adjust meter along with
brief function instructions. The restore button resets the currently active function.
H Pos Centers the active video area within maximum display area. Adjust for minimal image loss
from side-to-side. Set the start point of the image on the left side. Adjust until the left edge of
the image is just visible, but not cutoff.
Pixel Clock (N) Reduces or eliminates vertical banding and focus problems by adjusting the length of each
horizontal line to match the computer line length. Adjust until the right side of the image
matches the display size or is not cut off by the border.
V Pos Centers the active video area within maximum display area. Adjust for minimal image loss
from top-to-bottom.
Top Flagging Reduces the image flagging, tearing or jittering at the top of the image.
Bottom
Flagging
Reduces the image flagging, tearing or jittering at the bottom of the image.
Blanking TOP, BOTTOM, LEFT, RIGHT - Use the blanking functions in case of wanted (active) video
information is cutoff or to eliminate any unwanted (non-active) video information. Use the
blanking function for the top, bottom, left and right until the desired effect is achieved.
Rename Once all parameters have been made and satisfied, use the RENAME function to name your
source. Use the <TAB> or

/

buttons until the text window is highlighted. Use the
keyboard to enter a new source name. Using the keyboard, enter the desired channel name
or press [Select] to accept the default name. Will overwrite existing channel name
Restore Use this function to undo the last changes prior to the last save. See Note below
NOTE: Channel data is saved when one of the following conditions occurs;
1.) 10-minutes after a change has been made, providing no other changes are made within
the 10-minute save window.
2.) A new channel has been selected, or an action occurs which selects a new channel or
source
3.) An explicit “Save As” command has been performed.