Ampro Corporation DLP 5200 - Manual (Page 7)

Un-packing and Packing
5
5200 User’s Manual
Un-Packing

Step 1. Remove the two (2) banding straps from around the shipping container.

Step 2. Remove the top section carton (item 1) by sliding it up and over the interior
sections.

Step 3. Remove the Plywood cover (item 2) and top foam insert (item 3).


Step 4. Remove the Lens (item 5) and accessories (item 4) from the hollow
compartments


Step 5. Carefully slide the main foam insert (item 6) up and over the projector.


Step 6. Loosen the top locking nut on all three level feet. See Detail A.

Step 7. Remove the four (4) wooden lags bolts (item 9) securing the two shipping bars
(item 8).


Step 8. With the shipping bars removed, carefully lift the projector off the floating platform
(item 10).


Step 9. Remove one leveling foot at a time and remove the flat washers then, reinstall
the leveling foot.

Step 10. Install the lens by carefully rotating the lens clockwise (CW) until it is firmly
attached.
!
When installing the lens, Do not over tighten or it will become difficult to remove.
Packing

Step 1. Remove the lens assembly by rotating it counterclockwise (CCW). Place the lens
in its’ protective bag.


Step 2. Place the projector on the floating platform (item 10).


Step 3. Slide the two shipping bars (item 8) in place, making sure a washer is above and
below the bar. Tighten the top lock nut down.

Step 4. Slide the main foam insert (item 6) around the projector. Place lens and any
accessories into the compartments and the rear of the main insert.
!
If the projector is being shipped for a service related issue, check with the service provider for what
accessories are required to be shipped with the projector.
Step 5. Place the top foam cover (item 3) and plywood cover (item 2) on top of the main
insert.
Step 6. Slide the outside carton over the entire assembly and secure with banding straps.
NOTE: If the projector is to be shipped back to the factory, be sure that the Return Authorization Number
(RA#) is cleared marked on the container.