AMX SIP Communications Gateway CSG-500 - Manual (Page 67)

Telephone System Configuration
59 CSG SIP Communications Gateway Operation/Reference Guide
The options associated with an application map are described below.
Click Save when you are done configuring this section. Then click Apply Changes to make these changes
immediately available for new calls.
Application Map Options
Enabled Select whether or not this application map is enabled.
Feature Name Specify a unique name to be associated with this application map.
Digits Specify the key sequence used to activate this feature.
Activate On/By Select which channel of the call that the application will be
executed on, and which channel is allowed to activate this
feature. The available settings are describe below.
• self - Run the application on the same channel that activated
this feature. This feature will be accessible by both the caller
and callee.
• peer - Run the application on the opposite channel from the one
that has activated this feature. This feature will be accessible
by both the caller and callee.
• self / caller - Run the application on the same channel that
activated this feature. This feature will be accessible by the
caller only.
• peer / caller - Run the application on the opposite channel from
the one that has activated this feature. This feature will be
accessible by the caller only.
• self / callee - Run the application on the same channel that
activated this feature. This feature will be accessible by the
callee only.
• peer / callee - Run the application on the opposite channel from
the one that has activated this feature. This feature will be
accessible by the callee only.
• self / both - Refer to the description for self.
• peer / both - Refer to the description for peer.
App Name Select the application to execute once the defined key sequence
is detected.
Note: The application map feature is not intended to be used for
all CSG applications. Applications which are statically defined in
the extensions.conf are executed by the PBX core. In contrast,
applications which are dynamically called from an application
map are executed outside of the PBX core. It is not appropriate to
use any application which has any concept of dialplan flow when
using an application map. Examples of this would be applications
such as Macro, Goto, Background, and WaitExten.
Arguments Specify the arguments to be passed to the application defined in
App Name.
Enabling the application map feature will cause the CSG to remain in the media
stream during all calls. This will occur regardless of whether two endpoints are
configured to redirect their media stream from the CSG to each other after the call
setup has completed (e.g. two SIP phones with reinvite enabled).