AMX SIP Communications Gateway CSG-500 - Manual (Page 78)

Device Configuration
70 CSG SIP Communications Gateway Operation/Reference Guide
FIG. 66 SIP Settings page
The following table describes the features on this page:
SIP Settings Options
Option Description
Back Returns you to the previous page. If you make a change on this
page, the Back button appears dimmed and is unavailable until
you press either Save or Cancel.
Connection
Status icon The icon in the upper-right corner of each Setup page shows
online/offline state of the panel to the master.
• Bright red - disconnected
• Bright green - connected. Blinks when a blink message is
received to dark green every 5 seconds for half a second then
go back to bright green.
• Bright yellow - panel missed a blink message from the master. It
will remain yellow for 3 missed blink messages and then turn
red. It will return to green when a blink message is received.
Note: A lock appears on the icon if the panel is connected to a
secured NetLinx Master.
Status This option enables the SIP Stack on startup. If you disable this
option, the panel will not attempt to read the rest of the
configuration and will not register with a proxy server. However,
point-to-point SIP will still be enabled allowing for existing
intercom functionality.
Connection State This option displays whether you are connected to the proxy
server.
Proxy Address This option enables you to enter the IP address or DNS name of
the proxy server that you want to use to register. The IP address
depends on whether you connect the touch panel to one of the IP
Phone ports or through the LAN with the CSG.