Nilfisk-ALTO RS 2200 - Manual (Page 133)

USER MANUAL ENGLISH
RS 2200 33019476(3)2010-02 A 11
Consultation of B_BOX • (7, Fig. J), where all the
alarms occurred after the last memory reset are stored.
The alarm is identifi ed by a number code that can be
displayed as shown below: repeatedly press the upper
part of the push-button (23, Fig. E) until “MAIN MENU”
appears. Confi rm by pressing the lower part of the
push-button (23, Fig. E). The arrow cursor (1, Fig. J)
will be placed near the word “STATUS”. Press the lower
part of the push-button (23, Fig. E) again to bring the
arrow cursor near the word “MAINTENANCE”. Confi rm
by pressing the upper part of the push-button (23, Fig.
E). On the display (32, Fig. E) the page “MAINT.01”
is shown; when pressing the upper part of the push-
button (23, Fig. E) again, the page “MAINT.02” is
shown. When pressing the lower part of the push-
button (23, Fig. E), the cursor aligns with B_BOX,
then enter the B_BOX by pressing the upper part of
the push-button (23). In this page, the fi rst series of
numbers (33, Fig. J) indicates the alarm identifi cation
number, while the second series of numbers (34)
indicates the time at which the alarm occurred. The
stored alarms are up to 16 displayed on four pages,
which can be scrolled by pressing the push-button
(23, Fig. E) repeatedly. The alarms shown are both
instrument inner alarms and CAN-BUS transmission
line inner alarms indifferently.
CAUTION!
In the B_BOX the alarms are stored one
after the other, so when the alarms are
detected, always check for the time at
which the alarm occurred to have a real
chronology of the alarms.
Machine layout description
(See Fig. F)
Fuel tank 1.
Right front water tank 2.
Right rear water tank 3.
Steering cylinder 4.
Right rear drive wheel 5.
Right front wheel 6.
Hopper 7.
Right side water tank drain plug 8.
Fuel tank fi ller cap 9.
Engine air fi lter 10.
Drive system pump 11.
Turbine pump 12.
Accessory pump 13.
Battery hygrometer 14.
Condenser electric fan 15.
Right front water tank lower fastener 16.
Right front water tank upper fastener 17.
Battery 18.
Hydraulic system oil tank drain plug 19.
Hand pump lever 20.
Compressor 21.
Coolant drain hose 22.
Dust control system pump fi lter 23.
Climate control system condenser 24.
Frame number 25.
Suction inlet-hopper branch pipe 26.
Suction fan assembly 27.
Hand pump 28.
Radiator fan motor 29.
DPF differential Pressure Sensor 30.
Vacuum modulators 31.