Nilfisk-ALTO RS 2200 User Manual
Page 139
USER MANUAL
ENGLISH
RS 2200
33019476(3)2010-02 A
17
ELECTRICAL FUSES
The machine is equipped with three fuse boxes (F3, F4 and F6)
in the cab and three maxi fuses inside the electrical box (32,
Fig. G). Here below there is a list of the circuits protected by the
above-mentioned fuses.
F2:
Cab and engine start fuse (40 A) (33, Fig. G)
–
16-way fuse box “F3” (16, Fig. D)
F3.1: Horn and windscreen wiper fuse (10 A)
–
F3.2: Headlights, combination switch and ceiling light
–
power supply fuse (25 A)
F3.3: Turn signal intermittence and audio unit power
–
supply fuse (15 A)
F3.4: Licence plate light, upper right running light, lower
–
right running light, left rear running light and light
buzzer fuse (7.5 A)
F3.5: Upper left running light, lower left running light, rear
–
right running light and running light indicator light
fuse (7.5 A)
F3.6: Low beam power supply fuse (10 A)
–
F3.7: Power supply and high beam indicator light fuse (10
–
A)
F3.8: Free
fuse
–
F3.9: Free
fuse
–
F3.10: Turn signal intermittence power supply fuse (+30)
–
(10 A)
F3.11: Flashing light fuse (10 A)
–
F3.12: Dashboard power supply, combination switch
–
control unit power supply, hour counter and driver’s
seat microswitch power supply fuse (7.5 A)
F3.13: Pedal neutral position fuse (10 A)
–
F3.14: Audio unit power supply (+30) and camera display
–
power supply D+ control relay energising fuse (10
A)
F3.15: Free fuse (10 A)
–
F3.16: Hopper sensor power supply fuse (10 A)
–
16-way fuse box “F4” (16, Fig. D)
F4.1: Free
fuse
–
F4.2: Drive pedal power supply and drive system
–
enabling relay energising fuse (5 A)
F4.3: Optional power supply fuse (+30) (10 A)
–
F4.4: Brake light fuse (10 A)
–
F4.5: Windscreen wiper motor, combination switch,
–
windscreen wiper relay power supply fuse (15 A)
F4.6: Hot water valve fuse (10 A)
–
F4.7: Free
fuse
–
F4.8: brake light microswitch, fuel fl oat power supply and
–
air fi lter sensor enabling fuse (7.5 A)
F4.9: Working light switch power supply fuse (20 A)
–
F4.10: Leaf spring height control switch power supply fuse
–
(10 A)
F4.11: Cab blower power supply and climate control
–
system fan power supply (25 A)
F4.12: Hydraulic system enabling switch fuse (5 A)
–
F4.13: Suction inlet working light fuse (15 A)
–
F4.14: Rear working light fuse (15 A)
–
F4.15: Front working light fuse (15 A)
–
F4.16: Free fuse
–
16-way fuse box “F6” (16, Fig. D)
F6.1: Cigarette lighter fuse (20 A)
–
F6.2: Optional power supply fuse (10 A)
–
F6.3: Diagnostic socket fuse (10 A) (41, Fig. F)
–
F6.4: Free fuse (15 A)
–
F6.5: Free fuse (7.5 A)
–
F6.6: Engine valve power supply, AIA electronic board
–
power supply and warning light resistance fuse (15
A)
F6.7: EDC power supply fuse (15 A)
–
F6.8: EDC power supply fuse (15 A)
–
F6.9: Compressor fuse (15 A) (35, Fig. G)
–
F6.10: Radiator fan fuse (30 A)
–
F6.11: Water-in-fuel sensor and diagnostic socket power
–
supply fuse (+30) (10 A)
F6.12: Speed sensor and hopper microswitch fuse (7.5 A)
–
F6.13: Gear speed electronic control board power supply
–
fuse (7.5 A)
F6.14: Working light enabling and start-prevention in
–
working mode fuse (10 A)
F6.15: Joystick, 3rd broom switch and working mode
–
signal fuse (10 A)
F6.16: Suction inlet and broom shifting, turbine and hopper
–
shifting fuse (20 A)
6-way fuse box “FX” (16, Fig. D)
FX.1: Main relay and start-up relay fuse (50 A) (42, Fig.
–
G)
FX.2: Glow plug fuse (40 A) (41, Fig. G)
–
FX.3: Fuel heater fuse (20 A) (35, Fig. G)
–
FX.4: Cab power supply fuse (+30) (50 A) (34, Fig. G)
–
FX.5: Free fuse (30 A) (33, Fig. G)
–
FX.6: Cab power supply fuse (40 A) (31, Fig. G)
–