Adding a single embedded appliance – Avocent Network Device SPC420 User Manual
Page 138
118 DSView 3 Software Installer/User Guide
these group memberships. Click Next. For more information, see Automatic Inheritance for
Group Memberships and Properties on page 135.
-or-
If you do not want to select groups at this time, click Do not inherit group membership.
6.
If one or more cascade switches are connected to the managed appliance, the Configure
Cascade Switches window will open.
a.
Select the type of cascade switch for each row from the menu in the Cascade Switch Type
column.
b.
Optionally, type a name for each row in the Name column.
c.
If two or more rows of a multiuser cascade switch are discovered, you can merge the rows
by selecting the checkboxes of those rows and clicking Merge. To undo the merge, click
the row of the merged switch and click Split. For information about other methods for
merging cascade switches, see Topology Synchronization on page 130.
d.
Click Next.
7.
The Apply Configuration Template window opens.
If you want to apply a configuration template to the appliance, select a template from the list
and click Next.
-or-
If you do not want to apply a configuration template to the appliance, select None and click
Next.
NOTE: For more information about configuration templates, see Appliance Configuration Templates on
page 137.
8.
Click Finish.
Adding a single embedded appliance
This procedure is valid only for IBM ASM RSA II, DRAC 4, HP iLO and NEC IPF embedded
appliances.
To add a single embedded appliance:
1.
In a Units View window containing managed appliances (see Accessing Units View windows
on page 106), click Add. The Add Appliance Wizard will open.
2.
The Select Add Unit Procedure window will open. Click Add a single appliance, then click
Next.
3.
If you were not in an appliance type Units View window when you clicked Add in the first
step, the Select Appliance Type window will open. Select an embedded appliance from the
product list, then click Next.
•
For an IBM ASM RSA II embedded appliance, go to step 4.
•
For a DRAC 4 embedded appliance, go to step 5.