Avocent Network Device SPC420 - Manual (Page 65)

Chapter 4: Basic Operations 45
To display or change the restrictions of a security zone:
1. In Internet Explorer, select Tools - Internet Options. The Internet Options dialog box appears.
2. Click the Security tab.
3. Select the security zone you wish to view.
4. Click Custom Level. The Security Settings dialog box appears.
5. Ensure that the following security settings are set to Enabled or Prompt. The Active Scripting
setting should be set to Enabled.
• Download Signed ActiveX Controls
• Run ActiveX Controls and Plug-Ins
• Launching Programs and Files in an IFRAME
• Active Scripting
6. Click OK to save the settings and close the Security Settings dialog box.
7. Click OK to close the Internet Options dialog box.
To add a hub server to the Trusted Sites list:
NOTE: If Trusted Sites security zone settings have been modified from their defaults, ensure that the correct
settings required for the DSView 3 software are specified, as indicated above.
1. In Internet Explorer, select Tools - Internet Options. The Internet Options dialog box appears.
2. Click the Security tab.
3. Click Trusted Sites, then click Sites. The Trusted Sites dialog box appears.
4. Type the web site address, in standard dot notation (xxx.xxx.xxx.xxx), for the DSView 3
software hub server (for example, https://10.0.0.1).
5. Click Add. The web site address will appear in the web sites list box.
6. Ensure that Require server verification (https:) for all sites in this zone is selected.
7. Click OK to save the settings and close the Trusted Sites dialog box.
8. Click OK to close the Internet Options dialog box.
Advanced Internet options
Internet Explorer contains advanced settings that may be specified to enhance use of the DSView 3
software. Changing these settings is not required, but is recommended for optimum results.
To specify advanced Internet options for the DSView 3 software:
1. In Internet Explorer, select Tools - Internet Options. The Internet Options dialog box appears.
2. Click the Advanced tab.
3. Select the following settings:
• Always send URLs as UTF-8