Avocent Network Device SPC420 - Manual (Page 317)

Chapter 20: Using the Telnet Viewer 297
6. Type the macro string in the Keystrokes box. For non-printing and special character code
sequences, use the following escape sequences:
New line: \n
Carriage return: \r
Form feed: \f
Horizontal tab: \t
Backspace: \b
Delay character (500 ms): \d
Hexadecimal code sequence: \0x<NN>, where <NN> is the hexadecimal byte. For example,
the
Ctrl+D character sequence may be sent by using 0x04.
Octal code sequence: \0<NNN>, where <NNN> is the octal byte. For example, the Ctrl+D
character sequence may be sent by using 0004.
7. From the Control Code menu, select the sequence to invoke with the selected characters.
8. In the Access Rights area, specify whether you wish for the macro to be a global macro
(available to all users) or a personal macro (available only to the current user).
You must have DSView 3 software administrator privileges to use the Access Rights area.
9. Click OK. The Configure Macros dialog box returns to its abbreviated display and the macro
appears in the Macros area.
10. Click OK to close the Configure Macros dialog box.
To edit an existing macro:
NOTE: You must have DSView 3 software administrator privileges to edit Global Macros.
1. Select Macros - Configure - Macros from the menu. The Configure Macros dialog box
appears.
2. In the Macros table, select the macro you wish to edit.
3. Click Edit. The Configure Macros dialog box expands to display an Edit Macro area
containing the information defined for the macro.
4. Edit the macro properties as needed.
5. Click OK. The changes are saved and the Configure Macros dialog box returns to its
abbreviated view.
6. Repeat steps 2-5 to edit additional macros.
7. Click OK to close the Configure Macros dialog box.
To delete a macro:
NOTE: You must have DSView 3 software administrator privileges to delete Global Macros.
1. Select Macros - Configure - Macros from the menu. The Configure Macros dialog box
appears.