Avocent Network Device SPC420 - Manual (Page 88)

68 DSView 3 Software Installer/User Guide
4. Specify the following Dial Up settings:
a. In the Server Prefix field, type the dial-up prefix for the DSView 3 server to obtain an
outside line. This prefix will be added to the unit phone number.
b. Enter the IP address range to be used in dial-up connections in the From address and To
address fields.
5. Specify the following Dial Back Settings:
a. In the Analog phone number field, type the analog phone number for the appliance to dial-
back to the DSView 3 server. This number will be stored in the DSView 3 software
database and automatically updated on the ACS console server.
b. In the Analog on hook time field, specify the on hook interval in the range of 0-25
seconds. The default value is 4 seconds. The on hook interval is the amount of time after
the initial dial-up connection is dropped before the modems on the DSView 3 server will
receive incoming calls.
c. Use the ISDN controller map field to define the map of Multiple Subscriber Numbers
(MSNs) to ISDN channels. Enter the controller map definition for each port sequentially
on a separate row in the text field. Use the following format:
<port number>:<MSN1>,<MSN2>
For example, if an Eicon card has one port, and MSN 21 is assigned to ISDN channel 1 on
port 1, and MSN 22 is assigned to ISDN channel 2 on port 1, the text in the ISDN
controller map field would be:
1:21,22
A controller map definition must be provided for each ISDN dial-back phone number.
d. In the ISDN phone number field, enter the Integrated Services Digital Network (ISDN)
phone number for the appliance to dial-back to the DSView 3 server. You may enter
multiple dial-back phone numbers each separated by a comma. The number(s) will be
stored in the DSView 3 software database and automatically updated on the ACS console
server.
e. In the ISDN on hook time field, specify the on hook interval in the range of 2-10 seconds.
The default value is 2 seconds. The on hook interval is the amount of time after the initial
dial-up connection is dropped before the modems on the DSView 3 server will receive
incoming calls.
NOTE: If your DSView 3 server is on Windows, the ACS console server username and password must be
configured as a user in Windows before a dial-back connection can be established.
6. Click Save.
Email
To specify email properties:
1. Click the System tab.