Alliance Laundry Systems 70269701R4 - Manual (Page 25)

Installation
23 70269701 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Position and Level the Tumbler
Remove lint panel door, and unscrew the four shipping
bolts (one at each corner). Remove tumbler from skid.
NOTE: Do not throw bolts away – they are the
leveling legs.
Remove four nuts from the literature packet, and
screw one fully onto each leveling leg.
Screw the four leveling legs (bolts) back into the level
adjusting fittings from the bottom.
Slide tumbler to its permanent location. Adjust the
leveling legs until the unit is level within 0.125 inch
(3.18 mm). Tumbler must not rock. Lock leveling legs
with nuts installed.
NOTE: The front of the tumbler should be slightly
higher than the rear (approximately 0.125 inch,
3.18 mm). This will prevent the clothes, while
tumbling, from wearing on the door glass gasket.
IMPORTANT: Keep tumbler as close to floor as
possible. The unit must rest firmly on floor so
weight of tumbler is evenly distributed.
Figure 2
Stacked Tumblers Only:
The stacked tumbler (T30) has a fifth leveling leg
which is enclosed with this manual. It MUST BE
installed on the lower left side of the blower housing
to stabilize the tumbler. Refer to Figure 3.
After leveling with the four cabinet leveling legs,
install the fifth so that it contacts the floor.
Figure 3
T451I
1 Plastic Cap
2 Leveling Leg
T451I
1
2
T467I
1 Fifth Leg
The stacked drying tumbler has a 5th
leveling leg on the blower housing. It is
very important to properly adjust this leg.
Unit is back heavy and could rock or tip.
W250
CAUTION
T467I
1