ADIC SNC 5100 - Manual (Page 107)

Updating Firmware and Configurations 99
6-00020-02
SNC 5100
If HyperTerminal reports an error, try to send the file again.
If the SNC 5100 reports an error, make a note of the error code and
see the Table 12, “Zmodem Status Codes,” on page 100 for further
information.
Saving a Configuration File
Step 1. From the HyperTerminal window enter sz “ config.cfg ”
<Enter> .
The filename “ config.cfg ” is an example of a name. You can
specify a different filename but it must be in quotes, it must be 8
characters or less and it must end in .cfg.
Step 2. From the HyperTerminal window select Transfer and Receive
File .
Step 3. From the Receive File dialog enter the path to the folder where
you want to save the file or click the Browse button and navigate to
it.
Step 4. For the Receiving protocol select Zmodem and press the Receive
button.
Step 5. Wait for the “Configuration Download Complete” status message to
be displayed on the service terminal indicating successful
completion.
If HyperTerminal reports an error, try to receive the file again.
If the SNC 5100 reports an error, make a note of the error code and
see the Table 12, “Zmodem Status Codes,” on page 100 for further
information.
Loading a Configuration File
Step 1. From the Hyper Terminal window, at the SN60023 > command
prompt, type rz and then press the Enter key.
Step 2. From the HyperTerminal window select Transfer and Send
File .