ADIC SNC 5100 - Manual (Page 85)

Virtual Private SAN®Scalar Firewall Manager Settings MAP 77
6-00020-02
SNC 5100
Virtual Private SAN®Scalar Firewall
Manager Settings MAP
Perform these steps if SFM devices are unavailable.
Check Scalar Firewall Manager Access Settings
Step 1. Connect the service terminal to the Service Port.
For more information, see “Connecting to the Service Port” on
page 95.
Step 2. Press the Enter key on the service terminal.
If the prompt is not displayed, go to “Service Port MAP” on
page 75.
Step 3. Enter the sfmShow -1 command from the service terminal.
For more information, see the "sfmShow [hostIndex]"
command on page 168
Step 4. If SFM State: Inactive is displayed, Scalar Firewall Manageris not
controlling access between the host and target devices. Proceed to
Step 5.
If SFM State: Active is displayed, Scalar Firewall Manager®is
controlling access between the host and the target devices. Proceed
to Step 8.
Step 5. Enter the sfmFeatureEnable command from the service
terminal.
For more information, see the or the "sfmFeatureEnable
“license key string”" command on page 166.
If SFM devices are available, exit this MAP.
If SFM devices are not available, proceed to Step 6.
Step 6. Enter the licenseShow command from the service terminal.